1980 Eureka earthquake

1980 Eureka earthquake
Palo Alto
Date November 8, 1980 (1980-11-08)
Origin time 10:27:34 UTC [1]
Magnitude 7.3 Mw [1]
Depth 6.2 mi (10 km) [1]
Epicenter 41°08′N 124°26′W / 41.13°N 124.44°W / 41.13; -124.44Coordinates: 41°08′N 124°26′W / 41.13°N 124.44°W / 41.13; -124.44 [1]
Type Strike-slip [2]
Areas affected North Coast (California)
United States
Total damage $2–2.75 million [2][3]
Max. intensity VII (Very strong) [3]
Peak acceleration .15–.25g [4]
Landslides Yes
Casualties Six injured [3]

The 1980 Eureka earthquake (also known as the Gorda Basin earthquake) occurred on November 8 at 02:27:34 local time along the northern coastal area of California in the United States. With a moment magnitude of 7.3 and a maximum Mercalli intensity of VII (Very strong), this strike-slip earthquake was the largest to occur in California in 28 years. Although damage was considered light, several loss estimates equaled or exceeded $2 million, and six injuries resulted when two vehicles came down with the partial collapse of a highway overpass on US 101 in Fields Landing. The north coast of California experiences frequent plate boundary earthquakes near the Mendocino Triple Junction and intraplate events also occur within the Gorda Plate.

Due to the regional seismic risk, the nuclear portion of the Humboldt Bay Nuclear Power Plant was shut down in the 1970s. No substantial damage occurred to the two fossil-fuel units that were still operational at the facility. Several types of sensors were installed at the site to capture strong motion data in this seismically-active area, but the majority of records from the event were considered unreliable due to faulty equipment or inadequate maintenance. Only one piece of equipment at the facility provided data by which an estimate of the peak ground acceleration could be made.

Tectonic setting

Near Cape Mendocino, the Mendocino Triple Junction is an area of active seismicity where three tectonic plates come together. The Mendocino Fracture Zone (also known as the Mendocino Fault east of the Gorda Ridge) is a transform fault that separates the Pacific and Gorda Plates. To the south, the relative motion between the Pacific Plate and North American Plate is accommodated by the San Andreas Fault, and to the north, the Gorda Plate is converging with the North American Plate at the Cascadia Subduction Zone. Earthquakes within the Gorda Plate are the result of north-south compression at the Mendocino Fault.[5]


USGS ShakeMap for the event

The left-lateral strike-slip earthquake was the largest to occur in California since the 1952 Kern County earthquake. The mainshock (which was described as a multiple-rupture, with four subevents in the initial 80 seconds) and its aftershocks occurred on a northeast-trending fault that extended from near the Mendocino Fault to a point northwest of Eureka. Movement along the fault is due to a north-south compressional regime and the resulting intraplate deformation of the Gorda Plate. Previous events in this area were the January 1922 7.3 Ms and the January 1923 7.2 Ms shocks.[6]

The earthquake occurred offshore (to the northwest of Eureka, about 37 mi (60 km) west of Patrick's Point) and had a maximum Mercalli intensity of VII (Very strong). Some people reported intense shaking that lasted for 15 to 30 seconds; tremors were felt as far south as the San Francisco Bay Area and as far north as Salem, Oregon. In the epicentral area, items were knocked off shelves and furniture was displaced, but damage was considered light (the smaller 5.2 ML event that occurred in June 1975 caused more damage).[7]


While most of the damage from the Gorda Basin earthquake was considered light, there were some exceptions. Mercalli intensities in the immediate area were judged to be in the range of V (Moderate) to VII. In Eureka, intensity VI (Strong) effects included broken windows and dishes, fallen chimneys, and merchandise that fell from store shelves. Intensity VII effects affected the Fields Landing, King Salmon, Loleta, and Big Lagoon areas, and included surface cracks on the ground, soil liquefaction, small landslides and rockfalls, and numerous slumps along the Eel River. Similar effects occurred along the Old Coast Highway near Trinidad and Moonstone, where the roadway was reduced to one lane of travel in some areas. Several homes were knocked off their foundations and a highway overpass collapsed in Fields Landing. Seismic wave amplification, poor design, or inadequate construction style may have contributed to losses there.[7][8]

Tompkins Hill Road overpass

The Tompkins Hill Road overpass is situated just south of Fields Landing and was built in the late 1960s. It suffered slight damage during the 1975 earthquake and was due for a retrofit in 1981. The overpass was constructed with cement abutments on earthen ramps on either end and a series of concrete support columns in the middle. Eight 60 ft (20 m) reinforced concrete spans accommodated northbound and southbound lanes of traffic, with no anchors connecting the spans with each other or to the abutments. At the time of the shock, two of the southbound spans came off their support (a 6 in (15 cm) ledge) and six people were injured when a Volkswagen Beetle and a small pickup truck plummeted off the bridge.[7]

Selected Mercalli intensities
MMI Locations
VII (Very strong) Fields Landing, CA
VI (Strong) Eureka, CA, Arcata, CA
V (Moderate) Crescent City, CA, Scotia, CA
IV (Light) Fallon, NV, Roseburg, OR
III (Weak) Salem, OR, Palo Alto, CA
Earthquake Intensity Database, National Geophysical Data Center

Humboldt Bay Power Plant

The Humboldt Bay Power Plant is located about 3 miles (4.8 km) north of the collapsed highway overpass and operated fossil-fuel and nuclear units in the 1960s and 1970s. The nuclear unit was cancelled in 1976 because of seismic safety concerns, but the two fossil-fuel units remained in operation. The Nuclear Regulatory Commission performed a post-event survey of the facility's systems in late 1980, but inspectors found only minor effects to the plant's structure, piping, tanks, and other mechanical equipment. It was found that the two units were automatically shut down at the time of the shock for various protective concerns and that there were minor cracks in masonry and concrete, sheared bolts, pipe leaks, and slight movement of water tanks. The deformation of a reinforced masonry wall that resulted in a variable-width gap was the only structural issue.[4]

Strong motion

Pacific Gas and Electric initially reported that peak ground accelerations in the range of .16–.4g were recorded on the floor of the refueling building on the plant's strong motion instruments (accelerometers). Low voltage from a faulty power supply left the instruments in a condition that was functional, but the records were not considered reliable. Three TERA Technology film recorders were also in use as a backup system, but these instruments also did not produce any usable records, because lack of maintenance had allowed dirt and grit to get inside. Only records from one instrument (an Engdhal peak shock recorder) was believed to be operating correctly and, with a close examination of the energy dispersed at various frequencies, an estimate of .15–.25g was given for the event at that location.[4]


  1. 1 2 3 4 ISC (2015), ISC-GEM Global Instrumental Earthquake Catalogue (1900–2009), Version 2.0, International Seismological Centre
  2. 1 2 USGS (September 4, 2009), PAGER-CAT Earthquake Catalog, Version 2008_06.1, United States Geological Survey
  3. 1 2 3 Stover, C. W.; Coffman, J. L. (1993), Seismicity of the United States, 1568–1989 (Revised) – U.S. Geological Survey Professional Paper 1527, United States Government Printing Office, pp. 95, 168
  4. 1 2 3 Herring, K. S; Rooney, V.; Chokshi, N. C. (1981), Reconnaissance report : effects of November 8, 1980 earthquake on Humboldt Bay Power Plant and Eureka, California area, U.S. Nuclear Regulatory Commission, pp. 1–8
  5. Bakun, W. H. (2000), "Seismicity of California's North Coast", Bulletin of the Seismological Society of America, Seismological Society of America, 90 (4): 797, 798
  6. Lay, T.; Given, J. W.; Kanamori, H. (1982), "Long-period mechanism of the 8 November 1980 Eureka, California, earthquake", Bulletin of the Seismological Society of America, Seismological Society of America, 72 (2): 439, 440, 455, 456
  7. 1 2 3 Lajoie, K.; Keefer, D. (1981), Investigations of the 8 November 1980 earthquake in Humboldt County, California, Open-File Report 81-397, United States Geological Survey, pp. 1, 4, 8, 9, 12–16
  8. Kilbourne, R. T.; Saucedo, G. J. (1981), "Gorda Basin Earthquake, Northwestern California", California Geology, 34 (3): 53–57

External links

This article is issued from Wikipedia - version of the 10/29/2016. The text is available under the Creative Commons Attribution/Share Alike but additional terms may apply for the media files.