Variable-range hopping

Variable-range hopping, or Mott variable-range hopping, is a model describing low-temperature conduction in strongly disordered systems with localized charge-carrier states.[1]

It has a characteristic temperature dependence of

for three-dimensional conductance, and in general for d-dimensions

.

Hopping conduction at low temperatures is of great interest because of the savings the semiconductor industry could achieve if they were able to replace single-crystal devices with glass layers.[2]

Derivation

The original Mott paper introduced a simplifying assumption that the hopping energy depends inversely on the cube of the hopping distance (in the three-dimensional case). Later it was shown that this assumption was unnecessary, and this proof is followed here.[3] In the original paper, the hopping probability at a given temperature was seen to depend on two parameters, R the spatial separation of the sites, and W, their energy separation. Apsley and Hughes noted that in a truly amorphous system, these variables are random and independent and so can be combined into a single parameter, the range between two sites, which determines the probability of hopping between them.

Mott showed that the probability of hopping between two states of spatial separation and energy separation W has the form:

where α−1 is the attenuation length for a hydrogen-like localised wave-function. This assumes that hopping to a state with a higher energy is the rate limiting process.

We now define , the range between two states, so . The states may be regarded as points in a four-dimensional random array (three spatial coordinates and one energy coordinate), with the "distance" between them given by the range .

Conduction is the result of many series of hops through this four-dimensional array and as short-range hops are favoured, it is the average nearest-neighbour "distance" between states which determines the overall conductivity. Thus the conductivity has the form

where is the average nearest-neighbour range. The problem is therefore to calculate this quantity.

The first step is to obtain , the total number of states within a range of some initial state at the Fermi level. For d-dimensions, and under particular assumptions this turns out to be

where . The particular assumptions are simply that is well less than the band-width and comfortably bigger than the interatomic spacing.

Then the probability that a state with range is the nearest neighbour in the four-dimensional space (or in general the (d+1)-dimensional space) is

the nearest-neighbour distribution.

For the d-dimensional case then

.

This can be evaluated by making a simple substitution of into the gamma function,

After some algebra this gives

and hence that

.

Non-constant density of states

When the density of states is not constant (odd power law N(E)), the Mott conductivity is also recovered, as shown in this article.

See also

Notes

  1. Mott, N.F. (1969). "Conduction in non-crystalline materials". Phil. Mag. 19: 835.
  2. P.V.E. McClintock, D.J. Meredith, J.K. Wigmore. Matter at Low Temperatures. Blackie. 1984 ISBN 0-216-91594-5.
  3. Apsley, N. & Hughes, H.P. (1974). "Temperature-and field-dependence of hopping conduction in disordered systems". Phil. Mag. 30: 963.
This article is issued from Wikipedia - version of the 6/6/2016. The text is available under the Creative Commons Attribution/Share Alike but additional terms may apply for the media files.